Dobot CR5 - Page 7

DOBOT CR5 User Guide 1 Security Precautions
Issue V3.5.3.1 (2020-05-09) User Guide Copyright © Yuejiang Technology Co., Ltd
2
circuit, otherwise, it is vulnerable to injury the device or the person.
 You should comply with the local laws and regulations when operating the robot.
The security precautions in this document are only supplemental to the local laws
and regulations.
 Please use the robot in the specified environment scope. If not, exceeding the
specifications or load conditions will shorten the service life of the robot, even
damage it.
 Please ensure that the robot is operated under the security conditions and there is no
harmful object around the robot.
 Turning on or off the power continually may result in that the performance of the
main circuit components inside the controller is degraded. If turning on or off the
power continually is required, please keep frequency less than once a minute.
HOT
 The robot and the controller will generate heat during operation. Please do not
operate or touch the robot when the robot is working or has just stopped working.
 Turn off the power and wait an hour for the robot to cool down.
 Do not put your fingers where the control cabinet gets hot.
NOTICE
 The personnel responsible for installation, operation and maintenance of equipment
must first undergo rigorous training, understand various safety precautions, and
master the correct operation and maintenance methods before they can operate and
maintain equipment.
 Personnel without professional training shall not disassemble and repair the
equipment without authorization. If the device fails, please contact Shenzhen
Yuejiang Technology Co., Ltd technical support engineer in time.
 Be sure to carry out daily inspections and regular maintenance, and replace faulty
components in time to ensure the safe operation of the equipment.
 If the equipment is scrapped, please comply with relevant laws to properly handle
industrial waste and protect the environment.
 In order to prevent personnel from accidentally entering the working space of the
robotic arm, be sure to set up safety fence to prevent personnel from entering the
hazardous area.
 Before operating the robot, make sure that no one is inside the safety fence. When
operating the robot, be sure to operate outside the safety fence.
 Do not expose the robot to permanent magnetic fields all the time. Strong magnetic
fields can cause damage to the robot.