SECTION 6 Field Replaceable Parts
0855855eng 6/08 6–7
4.5 Final Steps
When paragraphs 3.2 through 3.4 are complete:
1. Connect the power cable and power on the Model 5200/5400.
2. The cold printhead requires 15 minutes to heat.
3. When the printhead is nearly ready, tighten the ink line fitting.
4. When the printhead is ready, perform a purge and jet test.
5. Position the printhead for proper jetting distance (6mm or
0.25in.).
Figure 6–4
NOTE: Model 5000 printheads are NOT interchangeable with Model
5200/5400 printheads.
To Next Page
Loading...
