SECTION 6 Field Replaceable Parts
0855855eng 6/08 6–33
14 Replacing the Soft Start Board
14.1 What You Will Need
• Large flathead screwdriver
• #1 Phillips screwdriver
14.2 Preparation
1. Power off the Model 5200/5400 and disconnect the power
cable.
2. Remove the front cover by loosening the five large captive
screws.
NOTE: The cover ground wire may need to be disconnected from
the print station.
14.3 Removal
1. Disconnect the transformer plug(s) from the soft start board (1,
Figure 6-26).
2. Loosen the screw securing the left wire attached to the terminal
block (2, Figure 6-26).
Note the position/voltage at which this wire connects. This
determines the voltage configuration of the machine and must
match the incoming voltage. Refer to the Installation and
Setup Guide, Section 2, Changing the Voltage
Configuration.
3. Remove the screw securing the wire attached at the right end
terminal block position (3, Figure 6-26). It has a ring tongue
terminal.
4. Remove the single Phillips screw holding the soft start board
(4, Figure 6-26).
5. Lift the board up and off the keyhole standoffs.
To Next Page
Loading...
