SECTION 3 Care and Cleaning
0855855eng 6/08 3–9
5 Stuck Bottle Removal
If the melt cycle is interrupted or a deformed bottle is inserted into
the melt chamber, the fault message “Ink Bottle Stuck” (W241)
may result.
• Clear the fault message (W241) and let the next melt cycle
complete the melting of the ink.
• To temporarily unlock the ink load door, go to the
Diagnostics Menu /Print Station/Ink Door Solenoid.
If the partially melted bottle of ink is deformed, it should be
discarded, as it may not be able to slide down the melt tube.
If the bottle looks good, it can be inserted again.
NOTE: If the bottle of ink cannot be removed, it may be necessary to
heat the melt chamber externally with a heat gun.
To Next Page
Loading...
Need help?
General