Dover Markem-Imaje 5200 - Printhead Lamp; Encoder Speed; Purge Button; Purge Count

SECTION 4 Diagnostic Tools
4–14 0855855eng 6/08
2.4.13 Printhead Lamp
Parameter Options: On, Off
Access Level: Read–3; Write–3
The Printhead Lamp parameter indicates the state of the amber
LED on the printhead.
2.4.14 Encoder Speed
Access Level: Read–3
The Encoder Speed parameter indicates the speed of the conveyor/
product. The units of measure are established at Machine Setup.
2.4.15 Purge Button
Parameter Options: On, Off
Access Level: Read–3; Write–3
The Purge Button parameter indicates the current state of the
printhead purge button and provides the ability to purge the
printhead remotely.
2.4.16 Purge Count
Access Level: Read–3
The Purge Count parameter counts the number of manual purges.
Note that printhead firmware 2403049E or later is needed to support
this feature.
2.4.17 Jet Test Button
Parameter Options: On, Off
Access Level: Read–3
The Jet Test parameter indicates the current state of the printhead
jet test button.