SECTION 3 Care and Cleaning
3–6 0855855eng 6/08
3. If any jets are not working properly, repeat the Purge and Jet
Test procedures. DO NOT WIPE the jet array unless several
attempts at purging are unsuccessful in recovering jets.
2.3 Wiping
CAUTION: Hot Surfaces. To prevent injury from burns, be
careful not to touch the jet array surface or hot ink directly.
Wear protective eyeglasses when working with hot ink.
The jet array should be wiped ONLY:
• If several attempts at purging are unsuccessful in recovering jets.
• Or in the down jetting position, after each purge.
1. Using a Markem-Imaje Printhead Wipe, wipe the jet array from
the center out.
DO NOT scrub the jet array.
DO NOT drag contaminants across the jet array.
Wipe outward from the center.
2. Clean any ink buildup around the jet array area and in the
corners of the enclosure near the jets.
To Next Page
Loading...
Need help?
General