SECTION 6 Field Replaceable Parts
0855855eng 6/08 6–25
Figure 6–19
NOTE: Before removing the printhead volt board, take note of how
the two ribbon cables are folded behind the printhead volt board to
be able to repeat the same folding when installing the new printhead
volt board. An example of a folded ribbon cable for the left-hand
side is shown below (Figure 6-20).
Figure 6–20
7. Slide the volt board forward and off the six keyhole standoffs.
8. Disconnect the two ribbon connectors from the backplane board.
To Next Page
Loading...
