Trends/data dialogs
172 Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n
Selecting an interval
The interval that applies to the three graphical
trends can be set.
To set the interval
1 Select the Duration button (F).
2 Choose one of the following durations: Off,
1min, 5min, 10 min (default), 15 min,
20 min, 30 min, 45 min, 1h, 90 min, 2h, 4 h.
3 Select the OK button (C) to confirm the
selection. Select the Cancel button (D) to exit
the screen without accepting the changes.
Printing an Analysis tool graphical trend
report
A graphical trend report for recruitment contains the
initial and end cursor values and the Δvalue for
each parameter. graphical trend report for
recruitment can be printed only after you set the
cursors. Otherwise the Print button remains grayed
out and cannot be selected.
To print a recruitment graphical trend report
1 Select the Procedures... button from the main
menu bar.
2 Select the Analysis tool tab.
3 Set both cursor buttons (see page 171).
4 Select the Print button.
Tabular trend
The tabular trend displays trend data in data
columns. Trend data are updated according to the
selected time scale. For example, if the current time
scale is 15 minutes, the trend display is updated
every 15 minutes. A time stamp above each
column marks the interval during which the data in
that column was collected. The displayed value is
the last acquired value during that interval. The
column on the right side is reserved for the most
recent data. Certain parameters and special
conditions, such as artifact, are represented in
unique ways (see page 162).
To access the tabular trend
1 Select the Trends/ Data... button on the main
menu bar.
2 Select the Trends tab (if not already selected).
3 Select the Table tab (if not already selected).
To Next Page
Loading...
