SpO2 and pulse rate with Nellcor OxiMax MCable
276 Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n
Applying the sensor
If you are using a reusable sensor, make sure it is
clean before applying it to the patient. Follow the
recommendations of the manufacturer.
To apply the sensor
1 Select the size and type of sensor that is best
suited for your patient. Follow the
recommendations of the manufacturer.
2 Position the sensor correctly and attach it to
your patient.
3 Connect the sensor to the Nellcor OxiMax
MCable.
WARNING
Inspect the application site every two to three
hours to ensure skin quality and correct opti-
cal alignment. If the skin quality changes,
move the sensor to another site. Change the
application site at least every four hours.
NOTE
Read the instructions provided with the sensor for
optimal application techniques and for safety in-
formation. Never use damaged sensors. Doing so
may compromise performance.
330
NOTE
After connecting the sensor, do the following if the
sensor-LED does not light up:
– Observe the monitor for any message and act
accordingly
– Replace the sensor.
To Next Page
Loading...
