External devices – Evita 2D, Evita 4, Evita XL (Medibus)
438 Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n
To view loops
1 Select the Sensor parameters... button on the
main menu bar.
2 Select the Ventilator tab. If you cannot see the
tab, select the following two symbols located in
the upper right corner of the dialog:
– symbol
– display filter button
3 Select the PV Loop tab to view pressure-
volume loops or select the FV Loop tab to view
flow-volume loops.
4 Select the Loops tab to view all loops in one
dialog.
5 Select the Loop draw button at the bottom of
the page to choose how many loops are drawn
on top of each other before the screen is
cleared.
6 Select the Save reference button at the bottom
of the page if you want to save a loop for future
analysis and comparison.
The Show all page
The Show all page displays the values of the
currently monitored ventilator parameters and units
of measure in one screen.
To access the ventilation show all page
1 Select the Trends/ Data... button on the main
menu bar.
2 Select Trends > Ventilator > Show all
or
1 Select the Sensor parameters... button on the
main menu bar.
2 Select the Ventilator tab.
3 Select the Show all tab.
NOTE
Depending on which devices are connected to the
Cockpit, two Ventilator tabs may be displayed. If
you select the Ventilator tab and the selected
page has the message Medibus.X ventilator
devices displayed as a header, you have
selected the wrong Ventilator tab.
NOTE
Depending on which devices are connected to the
Cockpit, two Ventilator tabs may be displayed. If
you select the Ventilator tab and the selected
page has the message Medibus.X ventilator
devices displayed as a header, you have
selected the wrong Ventilator tab.
To Next Page
Loading...
