External devices – Servo-i ventilator
426 Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n
The Show all page
The Show all page displays the values of the cur-
rently monitored ventilator parameters and units of
measure in one screen.
To access the ventilation show all page
1 Select the Trends/ Data... button on the main
menu bar.
2 Select Trends > Ventilator > Show all
or
1 Select the Sensor parameters... button on the
main menu bar.
2 Select the Ventilator tab.
3 Select the Show all tab.
Accessing the parameter setup functions
1 Select Sensor parameters... from the main
menu bar > Ventilator tab to access the
Ventilator page. If you cannot see the tab, se-
lect the following two symbols located in the up-
per right corner of the dialog: symbol and
the display filter button.
2 Select either the Paw or the Vent tabs to access
the respective pages.
NOTE
The settings TVi, I (I:E) and E (I:E), also appear in
the Show all page in addition to the parameters.
NOTE
Depending on which devices are connected to the
Cockpit, two Ventilator tabs may be displayed. If
you select the Ventilator tab and the selected
page has the message Medibus.X ventilator de-
vices displayed as a header, you have selected
the wrong Ventilator tab.
NOTE
Depending on which devices are connected to the
Cockpit, two Ventilator tabs may be displayed. If
you select the Ventilator tab and the selected
page has the message Medibus.X ventilator de-
vices displayed as a header, you have selected
the wrong Ventilator tab.
To Next Page
Loading...
