Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n 63
Operating concept
– Changing the colors for individual parameters
(see, for example, how to change the color for
ECG on page 214)
– Changing the sweep speeds (see page 445)
Waveforms are drawn from left to right and can
contain the following information:
– Signal scales
–Grids
– Units of measure
– Parameter labels
– Pacer spikes
– QRS synchronization markers
– Respiration waveform markers to indicate
breath detection
– Messages (see page 63)
Freezing/stopping waveforms
Select the Freeze waveforms button on the
main menu bar.
All waveforms stop and the message Waveforms
stopped appears on each waveform channel. After
approximately 60 seconds, the waveforms start
scrolling again. To restart the waveforms earlier,
select the Freeze waveforms button again.
Freezing waveforms does not affect continuous
monitoring of all parameters and does not freeze
waveforms on the M540.
Supported messages
The Cockpit displays numerous messages that
indicate a special monitoring state that may affect
certain functionality. For example, when cardiac
bypass monitoring is activated, alarms are turned
off. The alarm message field of the header bar turns
red and the message Bypass Audio alarms
off appears.
For a complete list of these messages, see
"Messages" on page 513.
NOTE
If the acquired signal does not fit in the waveform
channel, the top of the waveform may appear
clipped.
To Next Page
Loading...
