Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n 87
Operating concept
Standby mode
Temporarily interrupt patient monitoring by placing
the Cockpit and the M540 in standby mode.
Selecting standby mode on the Cockpit
automatically activates standby mode on the M540
and vice versa. Likewise, taking a patient out of
standby on one device does the same at the other
device.
Standby mode has the following effect:
– All patient data are removed from display on the
Cockpit and the M540.
– All monitoring (including acoustic and optical
alarm signals) are suppressed.
– Active alarms are considered acknowledged.
– All recordings are canceled.
– The message Standby –Touch Screen to
resume monitoring is displayed in the center
of the screen.
To place the Cockpit in standby mode
1 Select the symbol next to the
Start/Standby... button on the main menu bar
to display the Standby toolbar.
2 Select the Standby button on the toolbar.
or
1 Select the Start/Standby... button on the main
menu bar to display the Standby dialog.
2 Select the Start tab if it is not already selected.
3 Select the Standby button next to the menu
selection Monitor.
The message Standby – Touch Screen to
resume monitoring appears in the center of the
Cockpit screen.
To take the Cockpit out of standby mode
Touch the screen to resume monitoring the vital
signs of the patient.
NOTE
If configured to appear on the main menu bar, the
Standby button is also accessible on the main
menu bar. For more information, see page 452.
To Next Page
Loading...
