Instructions for use – Infinity Acute Care System – Monitoring Applications VG6.n 61
Operating concept
The alarm status field
The alarm status field (F) of the header bar (see
page 509) indicates the current alarm status. The
following are some examples of alarm-related
symbols and messages that can appear in this
field.
For a complete list of supported messages, see
page 510.
For more detailed information on alarm monitoring,
see the “Alarms“chapter.
Monitoring area
The monitoring area of the Cockpit screen contains
waveforms and parameter fields that report the
current vital signs of the patient. The monitoring
area can also contain dialogs, mini-trends, an auto
view toolbar, ST parameters, vent loops, and so on.
The appearance of the monitoring area depends on
the selected view, which controls the layout and
content of the screen (see “Views“on page 74). The
appearance of the monitoring area also depends
on whether or not the split screen mode or mini-
trend display is selected (see page 458).
When opening a dialog, the waveform channels
and parameter fields are reduced to fit on the right
side of the screen (see figure on page 64). This
display behavior prevents the vital signs from being
obscured while the user is performing setup tasks.
Selecting the Home button on the main menu bar
or pressing the rotary knob closes any open dialogs
and refreshes the screen.
Symbol Label Description
Audio paused Appears with a timer when the yellow key located next to the rotary
knob is pressed.
n%
where n is the
numeric
percentage
The alarm volume percentage corresponding to the selected alarm
volume. The higher the alarm tone, the more the symbol is filled in
(50% in the example). If the symbol appears empty, the alarm
volume has been turned off (see next message).
Audio off Indicates that the alarm volume has been turned off, the Cockpit is
in OR mode or monitored by the ICS.
All alarms
paused
Indicates that all alarms are paused after selecting the Alarms... >
All alarms paused buttons.
All alarms off Indicates that all alarms are off after selecting the Alarms... > All
alarms off buttons.
To Next Page
Loading...
