Duplo DF-850 - 7-3. Energy-saving setting; 7-4. Paper stacking detection setting

49
Chapter3AdvancedOperation
Copyright © 2018 Duplo Corporation All Rights Reserved
[b]
[a]
2
Rotate the slant correction knob in the
direction of the arrow shown in the
figure, to adjust the misalignment.
Pin
Circular hole
3
After the operation is ended, return
the slant correction knob to its original
position.
The guide is a position where pin align with
round hole in the paper feed tray.
7. Function Settings
Functionsettingscanadjustinsupportofoperatingproceduresorvariouspapertypes,accordingtouse.
7-1. Operation modes
Operation mode refers to setting operations for the stoppers for the folding plate 1 and folding plate 2 when
thepowerisrstturnedon.
[STD] (Standard) Function for starting up in the normal setting condition when the power is turned on.
[LF] (Last fold mode) Function for starting up using the setting last used on the machine the previous time.
Ifthepoweristurnedoduringpaperfoldingoperation,thesettinginformationisnot
stored.
[SF](Stopper fixed mode) Function for omitting the operations panel setting when always processing using the
same conditions.
The machine is constantly set automatically using the same conditions.
Whenthepoweristurnedon,theinitialoperationisnolongerperformed.
Becauseautomaticsettingisperformedunderthesameconditions,thepapersizeand
folding mode cannot be changed.
Folding misalignment in the up or down direction will occur if the power is turned
onafterturnedoduringoperationofthefoldingstopperorduringtemporarystop
caused by opening the cover. In this case, be sure to press the C key while pressing the
keytoforciblyejectpaperwhenyouturnonthepower.