Duplo DF-850 - 5-3. B7, A6 size paper (For EU); 6. Adjusting Misalignment

43
Chapter3AdvancedOperation
Copyright © 2018 Duplo Corporation All Rights Reserved
4-2. Cross folding of non-standard size paper
Non-standardsizepaperreferstosizesofpaperotherthanthestandardsizepaper(6types).
Papercapableofcrossfoldingcomeswithinthefollowingrangeofpapersizesaftersinglefoldinghasbeen
performed.
Length:
182 to 432 mm/
7.17 to 17.00 inches
Width:
128 to 297 mm/
5.04 to 11.69 inches
Paper
feed
direction
Maximum:297x432mm/
(WxL)   11.69x17.00inches
Minimum:128x182mm/
(WxL)   5.04x7.17inches
For cross single folding, the processable minimum
papersizeisasfollows.
Minimum(WxL):90x128mm/3.54x5.04inches
Theoperatingprocedureisdescribedwithlength300mm/11.81inchespapersubjectedto"crosssingle
folding"astheexample.
1
Perform “Paper stacking” in “4-1. Cross folding of standard size paper”.
(p.39)
2
Set the paper size and folding mode.
DF-850
For NA
For EU
1) Movetheroughadjustmentknobofthe
foldingplate1tothe"75"/”2.95”position.
For the paper length calculation method, see
the“Roughadjustmentknobsetposition
table”(p.36).
2) Iftheroughadjustmentknobismisaligned
fromthescale,rotatetheneadjustment
knob either right or left, and align the rough
adjustmentknobtothescale.