B Safety Omega 2
4 Ambient conditions
The printer may only be operated under the specified ambient conditions
(→ Page 86 / Technical data).
5 Modifications, attachments and changes in
location
The printer is installed and commissioned by authorized Durst service
technicians.
The installation location of the printer may not be changed. Structural
stresses and strains are taken into account during installation. Any
change to the installation location or structural modifications to the
building must be app ro ved by Du rst Phototechnik AG.
Opening the printer housing, electronics case and covers, except for
routine work, and opening the workstation or unplugging the cable may
only be performed by authorized Durst service technicians.
Print heads may only be replaced by authorized Durst service technicians.
TheUVlampprotectionpreventsreflected light from drying out the ink in
the print head, thus damaging it. The UV lamp protection may therefore
not be removed.
6 Connection of external devices
The computer features a Fast Ethernet connection (SELV) for connection to
LAN/WAN networks. Only SELV-compatible peripheral devices approved by
Durst ma y be co nnected to the printer.
7 Electromagnetic compatibility
For users in the U S The printer has been tested and corresponds with the restrictions for a Class
A digital unit in agreement with the regulations of the FCC, Paragraph 15.
These restrictions serve to provide appropriate protection against harmful
interference with equipment used commercially. This printer generates, uses
and radiates energy in the radio frequency range and can, if not installed or
used in accordance with the requirements of these operating instructions,
cause harmful interference in radio communication. The use of the system in
a residential area can lead to such interference. In this case, damage/loss
caused by the interference are the fault of the user.
8 Specific types of danger
The printer has been constructed using state-of-the-art technology and
following the recognized technical safety regulations. Areas of danger which
cannot be avoided through design are provided with appropriate protective
equipment. If the printer is used improperly, however, the user or third
parties risk death or injury. The printer itself or another medium could also
be damaged.
14 / 9 1 2004 – 2014 © Durst Ph ototechnik AG – www.d urst-online .com , Omega 2, Issued 0 7/20 14
To Next Page
Loading...
