B Safety Omega 2
Ink supply unit with Durst re fill tank
Carriage guide
Light trap carrier
Uncuredinksonprintedmediaduetoinsufficient UV exposure
Observe the safety data sheets supplied with the ink.
Operate the printer with Durst inks only.
Wear protective gloves and safety goggles when cleaning the print
heads, adding ink or emptying the waste tray.
Avoid allowing ink to contact your face or eyes, e.g. by rubbing your eyes
with dirty hands.
If cont act with the skin occurs, wash affected areas with pH-neutral so ap
and water.
Carry out all specified inspection and cleaning work.
8.7 Risk of fire
Flammable media can ignite as a result of the UV lamps heating up.
Do not print media which have an ignition point of less than 80 °C (176
°F).
9 Protective clothing
9.1 Safety goggles and protective gloves
When cleaning the ink supply unit or the print heads, wear the protective
gloves provided for this purpose and recommended safety goggles
(→ Page 89 / Accessories and spare parts).
10 Handling inks and media
The operating personnel sh o uld familiarize themselves with the p rinter before
loading and unloading the media and inks.
10.1 Loading/unloading media
Since media have a considerable weight, ensure that your footing is
secure before loading/unloading.
Before loading/unloading, ensure that there are no obstacles near the
printer.
10.2 Refi lling ink
Use only the 1 L refill tanks intended for the printer (→ Page 89 / Ac-
cessories and spare parts).
16 / 9 1 2004 – 2014 © Durst Ph ototechnik AG – www.d urst-online .com , Omega 2, Issued 0 7/20 14
To Next Page
Loading...
