E Operation Omega 2
3.1 Switching on printer
✔ The workstation is booted up
✔ The software has been started
1. Switch on main switch on the printer.
2. Close s liding doo rs.
3. Click Printer in the software.
4. Selec t Printer tab.
5. Click Initialize.
The print ca rriage and all motors move to t he reference position.
The interface between the internal electronics and workstation is
initialized.
The UV lamp system is initialized.
The multiple spitting process is started.
The procedure is shown on the screen and is complete after approx.
3 minutes.
6. Start loading procedure (→ Page 35 / Loading a roll media),
(→ Page 43 / Aligning and printing a plate medium).
3.2 Switching off printer
The workstation is not disconnected from the power mains when the printer is
switched off.
1. Selec t Printer on the Software tab.
2. Click th e Daily button under Printer Shutdown.
The Printer Shutdown dialog window a
ppears.
3. Click Yes.
The print carriage moves over the light traps.
4. As soon as the switch-off cycle i
s reported in the software, click OK.
Energized components, e
ven when the printer has been switched off!
Risk of death via electric s hock
Switch main switch off.
5. Switch off printer with m ain switch.
30 / 9 1 2004 – 2014 © Durst Ph ototechnik AG – www.d urst-online .com , Omega 2, Issued 0 7/20 14
To Next Page
Loading...
