Maintenance - 2000h
ICA134-3EN2.pdf2012-04-13
Maintenance - 2000h
Park the roller on a level surface.
When checking and making adjustments, the
engine should be switched off and the
emergency/parking brake should be applied, if
not otherwise specified.
Park the roller on a level surface.
When checking and making adjustments, the
engine should be switched off and the
emergency/parking brake should be applied, if
not otherwise specified.
Ensue that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Ensue that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Hydraulic reservoir - Oil change
Fig. Hydraulic reservoir, bottom
1. Drain plug
1
Use a container to collect the used fluid. The container
should hold at least 45 liters (11.8 gal).
Observe caution when draining hot hydraulic fluid.
Wear protective gloves and goggles.
Observe caution when draining hot hydraulic fluid.
Wear protective gloves and goggles.
Place the container under the hydraulic reservoir.
Remove the drain plug (1) and allow the fluid to run
down into the container. Wipe clean and replace the
drain plug (1) in the hydraulic reservoir.
Save the oil and hand in to an
environment-friendly waste disposal station.
Save the oil and hand in to an
environment-friendly waste disposal station.
Fill up with fresh hydraulic fluid as per the instructions
under the heading "Hydraulic reservoir - Check fluid
level". Replace the hydraulic fluid filter at the same
time.
Start the diesel engine and operate the various
hydraulic functions.
Check the fluid level and top up if necessary.
95
To Next Page
Loading...
Need help?
General
