Operation - Driving
ICA134-3EN2.pdf2012-04-13
Operation - Driving
Operating the roller
Under no circumstances is the machine to be
operated from the ground. The operator must be
seated inside the machine during all operation.
Under no circumstances is the machine to be
operated from the ground. The operator must be
seated inside the machine during all operation.
2
6
3
1
Fig. Instrument panel
1. Starter switch
2. Engine speed control
3. Emergency stop
6. Forward/reverse lever
Set the speed control (2) in working position: High.
Check that the steering is working correctly by turning
the steering wheel once to the right and once to the
left while the roller is stationary.
Make sure that the area in front of and behind the
roller is clear.
Make sure that the area in front of and behind the
roller is clear.
Carefully move the forward/reverse lever (6) forwards
or backwards, depending on which direction of travel
is required.
The speed increases as the lever is moved away from
the neutral position.
The speed should always be controlled by using
the forward/reverse lever, and never by changing
the engine speed.
The speed should always be controlled by using
the forward/reverse lever, and never by changing
the engine speed.
Test the emergency stop by pressing the
emergency stop button (3) while the roller is
moving slowly forward. Brace yourself for a
sudden stop. The engine will be switched off and
the brakes activated.
Test the emergency stop by pressing the
emergency stop button (3) while the roller is
moving slowly forward. Brace yourself for a
sudden stop. The engine will be switched off and
the brakes activated.
Check while driving that the warning lamps have not
gone on.
43
To Next Page
Loading...
