Dynapac CA134 - Every 500 Hours of Operation (Every Three Months); Every 1000 Hours of Operation (Every Six Months); Every 2000 Hours of Operation (Yearly)

Maintenance - Maintenance schedule
ICA134-3EN2.pdf 2012-04-13
Every 500 hours of operation (Every three
months)
Refer to the contents to find the page number of the
sections referred to !
Pos. in
fig
Action CommentPos. in
fig
Action Comment
3 Replace fuel filter Refer to the engine manual3 Replace fuel filter Refer to the engine manual
32 Lubricate controls and joints32 Lubricate controls and joints
25 Change the engine oil and oil filter Refer to the engine manual25 Change the engine oil and oil filter Refer to the engine manual
7 Check air cleaner on hydraulic reservoir7 Check air cleaner on hydraulic reservoir
31 Check the belt tension for the drive system Refer to the engine manual31 Check the belt tension for the drive system Refer to the engine manual
Every 1000 hours of operation (Every six
months)
Refer to the contents to find the page number of the
sections referred to !
Pos. in
fig
Action CommentPos. in
fig
Action Comment
8 Change hydraulic fluid filter8 Change hydraulic fluid filter
9 Drain the condensate from hydraulic reservoir9 Drain the condensate from hydraulic reservoir
26 Drain condensate from fuel tank26 Drain condensate from fuel tank
22 Change oil in rear axle differential22 Change oil in rear axle differential
22 Change the oil in the rear axle pinion housing22 Change the oil in the rear axle pinion housing
23 Change oil in the rear axle planetary gearing23 Change oil in the rear axle planetary gearing
Every 2000 hours of operation (Yearly)
Refer to the contents to find the page number of the
sections referred to !
Pos. in
fig
Action CommentPos. in
fig
Action Comment
9 Change the hydraulic fluid9 Change the hydraulic fluid
12 Change the oil in the drum12 Change the oil in the drum
17 Check the steering joint17 Check the steering joint
70