Dynapac CA134 - Strike-Off Blade (Optional)

Operation - Starting
ICA134-3EN2.pdf 2012-04-13
Fig. Instrument panel
20. Vibration switch
20
Check while warming the engine that the warning
lamps for the oil pressure (24) and charging (28) go
out.
The warning lamp (25) should remain on.
When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature.
When starting and driving a machine that is cold,
remember that the hydraulic fluid is also cold and
that braking distances can be longer than normal
until the machine reaches the working temperature.
Fig. Control panel
28. Charging lamp
24. Oil pressure lamp
25. Brake lamp
29. Glow plug lamp
28
29
24
25
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Ensure that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Strike-off blade (Optional)
Fig.Strike-off blade
1. Locking pins (2 pcs)
1
1
Ensure always that the strike-off blade is
secured by the locking pins (1) when driving
with the blade in its raised position. Always
lower the blade to the ground before leaving or
parking the roller.
Ensure always that the strike-off blade is
secured by the locking pins (1) when driving
with the blade in its raised position. Always
lower the blade to the ground before leaving or
parking the roller.
42