Maintenance - 1000h
ICA134-3EN2.pdf2012-04-13
Maintenance - 1000h
Park the roller on a level surface.
When checking and making adjustments, the
engine should be switched off and the
emergency/parking brake should be applied, if
not otherwise specified.
Park the roller on a level surface.
When checking and making adjustments, the
engine should be switched off and the
emergency/parking brake should be applied, if
not otherwise specified.
Ensue that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Ensue that there is good ventilation (air
extraction) if the engine is run indoors. Risk of
carbon monoxide poisoning.
Hydraulic filter - Replacement
Fig. Hydraulic reservoir
1. Filler cap/Breather filter
1
Release the filler cap/breather filter (1) so that any
overpressure inside the reservoir is eliminated.
Check that the breather filter (1) is not clogged. Air
should be able to pass freely through the cap in both
directions.
If passage in either direction is blocked, clean the filter
with a little diesel oil and blow through with
compressed air until the block is removed, or replace
the cap with a new one.
Wear protective goggles when working with
compressed air.
Wear protective goggles when working with
compressed air.
89
To Next Page
Loading...
