3 Commissioning
3.11 Putting the SmartWire-DT into operation
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com 99
Figure 83:Determining the target configuration of the SWD system
All stations are addressed consecutively in ascending order. The physically
present actual configuration is determined on the SWD line. This is stored in
easy800-SWD retentively as the target configuration. The SWD-LED
indicates with a green continuous light that the target configuration matches
the actual configuration.
≧ 2 s
Config.
To Next Page
Loading...
