Eaton easy800

5 Function blocks
5.4 BT, Data block Transformer
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com 155
CPY mode, copy marker ranges
There is one source range and one destination range. The source range is
specified at >I1. The destination range is specified at >I2. The length of the
destination range is specified by the number of bytes at the >NO input.
The content of the source range is copied to the marker bytes in the
destination range.
The function block executes the copy operation if there is a rising edge from
1 to 1 at the BT..T_ (Trigger) coil.
The error outputs E1, E2 and E3 are evaluated regardless of the status of the
trigger.
Example 1:
Copy of marker blocks, direct definition of marker ranges
The value of marker byte 10 to 14 is to be transferred to marker bytes 20 to
24.
• Parameters of function block BT01:
After a rising edge from 0 to 1 at coil BT01T_ the content of MB10 to MB14
is copied to the marker bytes MB20 to MB24.
• Source range: I1 MB10
• Target range: I2 MB20
• Number of bytes: NO 5
Source
range
Value of
source
marker range
(decimal)
Destination
range
Value of
destination
marker
range
(decimal)
MB10 42 MB20 42
MB11
27 MB21 27
MB12
179 MB22 179
MB13
205 MB23 205
MB14
253 MB24 253