5 Function blocks
5.11 D, text display
184 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Display examples
Figure 126:Text output examples
Setpoint entry in a display
This function is available for easy800-SWD from device version 01 and for
easy800 standard from device version 04.
Example:
The setpoint of timing relay T01 is to be changed from 12 s to 15 s.
• Line 1: Actual value of timing relay T 01
• Line 2: Setpoint of timing relay T 01, editable
▶ Pressing the ALT pushbutton will cause the cursor to jump to the first
editable value.
In this operating mode, you can use the cursor buttons ÍÚ to move between
editable constants.
▶ Press the OK pushbutton to move the cursor to the least significant value
of the constant to be modified.
In this operating mode you use the ÍÚ cursor buttons to change the value.
Use the cursor buttons ú í to move between places.
Use the OK pushbutton to accept the modified value. Use the ESC
pushbutton to abort the entry and leave the previous value.
▶ Press the OK pushbutton, the cursor will move from constant to
constant.
The modified value is accepted.
Press the ALT pushbutton in order to leave Entry mode.
(The ESC pushbutton has the same function here.)
Counter with actual value Temperature values of an
easyNet station
D1 as error message on fuse
failure
￫
When values are being entered, the text is retained statically on
the display. The actual values are updated.
To Next Page
Loading...
