Eaton easy800

5 Function blocks
5.30 SR, shift register
248 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Figure 181:DW operating mode, wiring the function block contacts
You assign parameters to inputs and outputs in the function block diagram.
Parametric programming of the function block inputs/outputs
When using the function block in the circuit diagram for the first time, use
OK to automatically enter the general display of function block parameters
(￫ Page 249 figure left). Enter the function block settings here.
Operating mode
With this parameter you define whether you wish to run the shift register as
a bit register or in double word format.
The factory setting of this parameter is BIT.
Parameters
Function, parameterization in the function block
BIT Bit operation
DW
Double word operation
￫
If the BIT operating mode is selected, the inputs I1, I2 and
outputs D1-D8 are displayed. They have no function in BIT
mode! If they are assigned operands, these will have no effect.
The wiring of the SR function block (BIT) is carried out in the
circuit diagram.
M 05--------------------------Ä SR01EN
M 06--------------------------Ä SR01FP
M 07--------------------------Ä SR01BP
M 08--------------------------Ä SR01RE