Eaton easy800

5 Function blocks
5.35 Example with timing relay and counter function block
270 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Figure 203:Wiring with easy800
Enter circuit diagram
▶ Enter the following circuit diagram.
Figure 204:Wiring of counter and timing relay
Entering function block parameters
If you enter the coils or contacts of a function block, the inputs/outputs of the
function block are displayed that you can parameterize. The parameters can
be entered via the function blocks menu.
The meaning of these parameters is explained under each function block
type.
Entry:
The first part of the parameter set of a counter is displayed.
▶ Move the cursor
í over the “+“ character to the value entry behind >SH:
•
>SH means: Function block input upper counter setpoint value.
• The + character means that the parameters of this timing relay can be
modified using the PARAMETERS menu.
▶ Change the upper counter setpoint to 10:
• Use úí to move the cursor onto the tens digit.
• Use ÍÚ to modify the value of the digit.
▶ Press OK to save the value and ESC to return to the circuit diagram.
▶ Set the parameters for T 01.
1
2
E1
L01–
S2
L01+
L01–
+24 V
0 V I5 I6
S1
Q 1
I05---------------------------Ä C 01C
I06---------------------------Ä C 01RE
C 01OF-------------------------Ä T 01EN
T 01Q1-------------------------Ä Q01
C 01 +
>SH +10
>SL
>SV