2 Installation
2.4 Connecting the power supply
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com 27
AC-800 standard
Figure 15:Power supply on easy800 standard AC version
CAUTION
When the basic devices and expansion units are switched on,
they behave like a capacitor, so that an inrush current higher
than the rated input current is present.
Take this inrush current into account when designing the
electrical equipment by using slow fuses and suitable switches.
Never use reed relay contacts to switch the supply voltage as
these may burn or stick.
When designing the DC power supply unit, bear the inrush
current in mind.
￫
The relevant connection data for the different device types
￫ section 12.3.3, “Power supply”, page 346.
DANGER
Ensure that the L and N conductor are not reversed.
To Next Page
Loading...
