3 Commissioning
3.10 Commissioning an Net network
92 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
3.10.1.1 Creating the station list
The station list is only important when selecting Loop-through cable routing.
The left-hand column shows the geographical position of the device on the
network. Use the number in the right-hand column to assign a NET-ID to the
device at this position. Position 1 is always assigned to NET-ID 1. You can
only assign each NET-ID once.
You create the station list in the STATION menu.
Only the physically first station with NET-ID 1 manages a station list.
You can only log in other NET stations via this NET station. The STATIONS
menu remains inactive for all other NET-IDs.
Figure 81:
Requirement: The easy800 device must be in STOP operating mode.
You must be in the NET-PARAMETER menu.
▶ Use the Í and Ú cursor buttons to select the STATION... menu and press
the OK pushbutton.
▶ Proceed to the station with physical position 2.
▶ Select the required physical location with the cursor buttons Í and Ú, in
this case position 2, and press OK.
▶ Select the NET ID 2 with the Í and Ú cursor buttons and confirm your
input with the OK button.
At physical position 2, the station has been assigned station address 2.
▶ Press ESC to return to the STATIONS menu item.
To Next Page
Loading...
