Eaton Network-M3 - Page 155

Maintenance
Contextual help of the web interface – 155
3.9.1.3.1 For other access rights
3.9.1.4 CLI commands
get release info
Description
Displayscertain basic information related to the firmware release.
Help
get_release_info
-d Get current release date
-s Get current release sha1
-t Get current release time
-v Get current release version number
3.9.1.4.1 For other CLI commands
3.9.1.5 Troubleshooting
The Network Module fails to boot after upgrading the firmware
Possible Cause
1- The IP address has changed.
2- The Network module LED shows solid red after the upgrade.
3- The first boot after the upgrade takes a longer time.
Note:If theapplication is corrupt, due to an interruptionwhile flashing the firmware for example, the boot will be done on
previous firmware.
Action
1- Recover the IP address and connect to the card.
2- Reset the Network module by using the Restart button on the front panel.
3- Wait until the Network module LED shows flashing green.
For other access rights, see the Information>>>Access rights per profiles section.
See the CLI commands in the Information>>>CLI section.