Eaton Network-M3 - Page 259

To Next Page

To Previous Page

List of event codes

Information – 259

2306 Warning Bypass breaker open Bypass breaker closed -

2309 Warning Output phases are rotated Output phases wired OK -

2322 Warning Battery temperature too high Battery temperature OK -

2326 Warning Bypass phase out range Bypass phase in range -

2327 Warning Bypass voltage out of range Bypass voltage in range -

2342 Warning Overload pre-alarm No overload pre-alarm -

2364 Warning Internal failure End of internal failure -

2366 Warning Bypass bad wiring Bypass wiring OK -

2369 Warning Battery low state of charge Battery state of charge OK -

2384 Warning Major alarm condition that makes

the device fail

No longer major alarm condition that

makes the device fail

2395 Warning Bypass frequency out of sync Bypass frequency no longer out of sync -

2396 Warning Input frequency out of sync Input frequency no longer out of sync -

2397 Warning Output frequency out of sync Output frequency no longer out of sync -

7.5.3.3 Info

Code Severity Active message Non-active message Advice

2014 Info Building alarm 6 No building alarm 6 -

2015 Info Building alarm 5 No building alarm 5 -

2016 Info Building alarm 4 No building alarm 4 -

2017 Info Building alarm 3 No building alarm 3 -

2018 Info Building alarm 2 No building alarm 2 -

2019 Info Building alarm 1 No building alarm 1 -

2038 Info Bypass AC sensor not

calibrated

Bypass AC sensor OK -

2039 Info Input AC sensor not calibrated Input AC sensor calibrated -

2040 Info Output AC sensor not

calibrated

Output AC sensor calibrated -

2041 Info Inverter sensor not calibrated Inverter sensor calibrated -

2042 Info DC bus sensor not calibrated DC bus sensor calibrated -

2043 Info Output AC current sensor not

calibrated

Output AC current sensor calibrated -

Related product manuals