Eaton Network-MS - Generic Command

www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card – User Manual 34003991XT_EN/JC Page 101/143
not allowed in command arguments except for the strings. The strings are in double quotes (“”).
The code colour is the following:
• Setting in read-write or write-only mode: light green
• Setting in read-only mode: yellow
• Warning message: green
• Error message: light red
The recognized commands are given in the following chapters and may be updated later.
6.4.1 Generic command
6.4.1.1 “help” and “?”
Purpose Display help about a specific command.
Syntax help [command] or [command] ?
Examples #> help getNetwork
#> getNetwork ?
6.4.1.2 “setEcho”
Purpose Hide, or not, all characters. If hidden, each character entered is replaced by an ‘*’
Syntax setEcho [option]
option :
ON
OFF
Examples #> setEcho ON
6.4.1.3 “quit”
Purpose Close a current CLI session
Syntax quit
Examples #> quit
6.4.1.4 “reset”
Purpose Software reset
Syntax reset
Examples #> reset
6.4.1.5 “version”
Purpose Get information about software versions
Syntax version
Examples #> version