Eaton Network-MS - Snmp Objects; Ietf Mib; EATON Pulsar MIB (Ex MGE)

www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card – User Manual 34003991XT_EN/JC Page 130/143
8.2 SNMP objects
8.2.1 IETF MIB
The Card implements the full IETF standard UPS MIB (RFC 1628), including the IETF alarm table and traps. Visit
http://tools.ietf.org for a description of the MIB. The UPS MIB access path is 1.3.6.1.2.1.33
8.2.2 EATON Pulsar MIB (ex MGE)
This section contains an overview of MIB definitions for each of the MIB files:
Eaton Pulsar MIB (MGE MIB)
Eaton Pulsar MIB (MGE MIB) for environmental sensors
The NMC implements the reduced Eaton Pulsar MIB (MGE MIB), only the objects listed in the following tables are
managed. The entire MIB description is available at http://download.mgeops.com
The Eaton Pulsar MIB access path is 1.3.6.1.4.1.705.1.
MIB object SNMP Format Add.path
upsmgIdentFamilyName String {1.1.0}
upsmgIdentModelName String {1.2.0}
upsmgIdentFirmwareVersion String {1.4.0}
upsmgIdentSerialNumber String {1.7.0}
upsmgConfigLowBatteryTime seconds {4.7.0}
upsmgConfigLowBatteryLevel % {4.8.0}
upsmgConfigAutoRestart 1(yes) 2(no) {4.9.0}
upsmgConfigVARating VA {4.12.0}
upsmgBatteryRemainingTime seconds {5.1.0}
upsmgBatteryLevel % {5.2.0}
upsmgBatteryVoltage deciVolts {5.5.0}
upsmgBatteryCurrent deciAmps {5.6.0}
upsmgBatteryFaultBattery 1(yes) 2(no) {5.9.0}
upsmgBatteryReplacement 1(yes) 2(no) {5.11.0}
upsmgBatteryLowBattery 1(yes) 2(no) {5.14.0}
upsmgBatteryChargerFault 1(yes) 2(no) {5.15.0}
upsmgBatteryLowCondition 1(yes) 2(no) {5.16.0}
upsmgInputPhaseNum {6.1.0}
mginputVoltage_1 DeciVolts {6.2.1.2.1.0}
mginputVoltage_2 DeciVolts {6.2.1.2.2.0}
mginputVoltage_3 DeciVolts {6.2.1.2.3.0}