Eaton Network-MS - System Menu; Shutdown Menu

www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card – User Manual 34003991XT_EN/JC Page 94/143
------------------------------------------------------------------------
NETWORK MANAGEMENT CARD
Trap receiver X
------------------------------------------------------------------------
1 : Hostname or IP address [xxx. xxx. xxx. xxx]
2 : Application mane [MyTrap]
3 : Trap Port (Default value: 162) [162 ]
3 : Trap community [ ]
4 : Protocol (Disabled, V1, V3, V1V3) [Disabled]
5 : MIB filter (b0=Pulsar, bit1=Power MIB, bit2=IETF) [2]
(1)
0 : Exit
----------------------------------------------------------------------
(1) Only the 3 less significant bits are used (b0 to b2). The possible value are from 0 to 7 (3 bits used set to 1).
6.3.6 System menu
This menu is used to view or modify the system settings.
------------------------------------------------------------------------
NETWORK MANAGEMENT CARD
System settings
------------------------------------------------------------------------
1 : UPS contact [Computer Room Manager]
2 : UPS Location [Room Manager]
3 : Item not available
4 : History log interval (sec) [50]
5 : Environment log interval (sec) [300]
6 : Item not available
7 : Language (AUTO,FRE,ENG,SPA, GER,ITA,CHI,CHT,JPN,KOR,CZI,RUS,POR) [AUTO]
0 : Exit
----------------------------------------------------------------------
6.3.7 Shutdown menu
This menu is used to view or modify the shutdown settings for the 3 outlets.
------------------------------------------------------------------------
NETWORK MANAGEMENT CARD
Shutdown settings
------------------------------------------------------------------------
1 : Master
2 : Outlet 2
3 : Outlet 3
0 : Exit
------------------------------------------------------------------------