Eaton Network-MS - System Settings; Trap Receivers; Access Control; Shutdown Settings

www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card – User Manual 34003991XT_EN/JC Page 85/143
6.2.2 System settings
These settings enable the customisation of the information on the UPS properties pages.
The parameter list is the following:
• UPS contact
• UPS location
• History log interval
• Environment log interval
• Default language
6.2.3 Trap receivers
This is the list of the supervision stations receiving traps. There is a maximum of 3 trap receivers.
The parameter list is the following:
• Receiver 1, 2 or 3 :
• Application name
• Host name
• Trap port
• Protocol
• Trap community
• MIB filter
6.2.4 Access control
These settings enable the configuration for secure access to the card via a web browser or SNMP. This menu can
also define Telnet/SSH/CLI procedure to access to the card.
The parameter list is the following:
• Login
• Password
• Security mode
• Telnet access
• Telnet security
• Console interface
6.2.5 Shutdown settings
These settings are used to define the behaviour of the UPS during a shutdown.
The parameter list is the following:
• Outlet 1 (main):
• Name
• Remaining time limit
• Remaining capacity limit
• Shutdown after