Eaton Network-MS - SNMP Settings; Date and Time; Environment Settings

www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card – User Manual 34003991XT_EN/JC Page 87/143
• Port
• Time Out
6.2.9 SNMP settings
These settings configure the 2 SNMP versions available, v1 and v3.
The parameter list is the following:
• Version
• SNMP port
• SNMP v1 community Read-Only
• SNMP v1 write enables
• SNMP v1 community write
• SNMP v3 user Read-Only
• SNMP v3 security Read-Only
• SNMP v3 password Read-Only
• SNMP v3 user Read-Write
• SNMP v3 security Read- Write
• SNMP v3 password Read- Write
• Notification user name
6.2.10 Date and time
These settings enable the initialisation of the date and time of the card in three different ways.
The parameter list is the following:
• Date & Time
• Type of synchronisation
• NTP host name
• Time-Zone
• Daylight saving time
6.2.11 Environment settings
These settings enable the configuration of the environment sensor. If not present, this menu is not available.
The parameter list is the following:
• Sensor name
• Temperature:
• Unity
• High threshold
• Low threshold
• Hysteresis
• Offset
• High notify