Eaton Network-MS - Choice 1: Restart; Reset; Choice 2: Network Configuration

www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card – User Manual 34003991XT_EN/JC Page 119/143
7.1 Choice 1: Restart / Reset
Use this function to restart the card from the boot
This is equivalent to a restart of the electrical power supply.
-----------------------------------------------------------------------------
Reset
-----------------------------------------------------------------------------
1 : Restart the card from the boot
0 : Exit
-----------------------------------------------------------------------------
7.2 Choice 2: Network Configuration
Use this function to access network settings.
-----------------------------------------------------------------------------
Network settings
-----------------------------------------------------------------------------
1 : Read Network settings
2 : Modify Network settings
3 : Set Ethernet speed
0 : Exit
-----------------------------------------------------------------------------
7.2.1 Choice 1: Read IPv4&IPv6 Network settings
Enables reading of the card's routine settings
Network configuration :
MAC address : 00:20:85:FD:1C:07
Mode : Static IP
IP address : xxx.xxx.xxx.xxx
Subnet mask : xxx.xxx.xxx.xxx
Gateway : xxx.xxx.xxx.xxx
Link Local IPv6 address : xxxx::xxxx:xxxx:xxxx:xxxx /xx
Global IPv6 address : xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx /xx
Global IPv6 address : xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx /xx