www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card
– User Manual 34003991XT_EN/JC
Page
14/143
IPP in connected mode in/out TCP 5000
IPP in UDP broadcast mode in/out UDP 4679, 4680R
RADIUS out UDP 1812*
LDAP out TCP 389*
* These ports can be changed by the user, the values shown are the defaults defined by the standards.
1.3.6 Environment sensor
• Temperature measurement from 0 to 70 °C with +/- 1 °C accuracy.
• Measurement of humidity from 0 to 100 % with +/- 6 % accuracy.
• Min / max time-stamped function for temperature and humidity.
• Choice of temperature readings in Celsius or Fahrenheit.
• High and low thresholds, hysteresis and offset adjustable via Web interface.
• Possibility of notification of status changes by e-mail, SMS or SNMP trap.
SMS notification requires the use of a third-party application that converts emails to SMS.
• Position detection of 2 dry contacts (maximum sensor/contact distance: 20 m).
• Name and status of each configurable contact.
• Recording of events and measurements in the card log
• Possibility of shutting down the installation in the event of a threshold being exceeded or on opening /
closure of a dry contact
• Connection to the card with straight shielded CAT5 RJ45 network cables (maximum card/sensor
distance: 10 m)
1.3.7 MIB (Management Information Base)
• The card is Compatible with following MIBs:
• MIB II (RFC 1213)
• Internet Engineering Task Force (IETF) Standard UPS MIB (RFC 1628)
• EATON Pulsar MIB (ex MGE) V1.7
• EATON Powerware MIB (PowerMib)
•
• See the appendix Chapter
To Next Page
Loading...
