Eaton Network-MS - Page 115

www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card – User Manual 34003991XT_EN/JC Page 115/143
6.4.9.3 “getTemp”
Purpose To read a temperature setting
Syntax getTemp [option1] [option2] ...
options :
Unit
HighThreshold
LowThreshold
Hysteresis
Offset
HighNotify
LowNotify
HighShutdown
LowShutdown
Examples #> getTemp Unit
Comments
6.4.9.4 “setTemp”
Purpose To modify a temperature setting
Syntax setTemp [option1] [option2] ...
options :
Unit = C|K
HighThreshold = xx
LowThreshold = xx
Hysteresis = xx (0..5)
Offset = xx (-5..5)
HighNotify = 0|1 (0=No, 1=Yes)
LowNotify = 0|1 (0=No, 1=Yes)
HighShutdown = 0|1 (0=No, 1=Yes)
(1)
LowShutdown = 0|1 (0=No, 1=Yes)
(1)
Examples #> setTemp Unit=C
Comments
(1)
: Writing enabled only if the notification is enabled
6.4.9.5 “getHum”
Purpose To read a humidity setting
Syntax getHum [option1] [option2] ...
options :
HighThreshold
LowThreshold
Hysteresis
Offset