www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card
– User Manual 34003991XT_EN/JC
Page
65/143
Connections with Intelligent Power Protector stay in standard mode (secure TCP)
SSL Security Implementation:
SSL version 3.0
TLS version 1.0
Method TLS_RSA_WITH_512_MD5
Certificate 1024 bits
Auth RSA
Key Exchange RSA
Encryption RC4_512
Digest MD5
Changes take effect after a card reboot
• Telnet access: This parameter enables the access to the setting parameters interface via a Telnet/SSHI
connection.
• Telnet security: This parameter defines the protocol for the access to the setting parameters interface.
These 2 values are mutually exclusive.
• TELNET: The data are read or written via an unsecured access.
• SSH: The data are read or written via a secured access.
• Console interface: This parameter defines the way to access the setting parameters. The 2 values are
mutually exclusive. The selected HMI (Human Machine Interface?) is available for the TCP/IP
connection (RS232 not concerned) and for the 2 protocols (Telnet, SSH). The new value will be taken
into account after a manual reset of the NMC.
• MENU: The HMI is a menu interface and the parameters are accessible via some pre-defined menus.
• CLI: The access to the parameters is done independently of each other using the command line
interface.
• Save: Saves any modifications.
To Next Page
Loading...
