Eaton Network-MS - Page 92

www.eaton.com
Network
Management Card
(Network-MS)
User Manual
Network Management Card – User Manual 34003991XT_EN/JC Page 92/143
------------------------------------------------------------------------
NETWORK MANAGEMENT CARD
Network settings
------------------------------------------------------------------------
: MAC address [00:20:85:FD:1C:07]
(3)
1 : BootP/DHCP (0=Disabled, 1=Enabled) [1]
2 : IP Address [xxx.xxx.xxx.xxx]
(1)
3 : Subnet Mask [xxx.xxx.xxx.xxx] (1)
4 : Gateway Address [xxx.xxx.xxx.xxx]
(1)
5 : Host Name [ups1]
6 : UPS Domain Name [ups.domain.com]
7 : IPv6 (0=No, 1=Yes) [0]
8 : IPv6 Auto-config (0=No, 1=Yes) [0]
(2)
9 : IPv6 add.1/prefix len. [ ]
(3)(5)
10 : IPv6 gateway address [ ]
(3)
11 : IPv6 local address
(4)
12 : IPv6 address 2
(4)
13 : Firmware upgradable (0=No, 1=Yes) [1]
14 : Primary DNS Server (IPv4 or IPv6) [xxx.xxx.xxx.xxx]
15 : Secondary DNS Server [xxx.xxx.xxx.xxx]
16 : SMTP menu
17 : SNMP menu
0 : Exit
----------------------------------------------------------------------
(1) Read-only or read-write according to “BootP/DHCP” status
(2) Read-only or read-write according to “IPv6 enabled” status
(3) Read-only or read-write according to “IPv6 enabled” and “IPv6 auto-config” status
(4) Read-only
(5) The value is a concatenation of the IPv6 address 1 and of the prefix length.
------------------------------------------------------------------------
NETWORK MANAGEMENT CARD
Network settings - SMTP
------------------------------------------------------------------------
1 : Hostname (for Email notification) [smtpserver]
2 : SMTP Port (Default Value: 25) [25]
3 : Authentication (0=No, 1=Yes) [1]
4 : Login [smtplogin]
(1)
5 : Password [*************]
(2)
0 : Exit
----------------------------------------------------------------------
(1) Read-only or read-write according to “Authentication” status
(2) Write-only or hidden according to “Authentication” status