ECKELMANN CI 3000 - 2.2 New Features Compared to Previous Versions

System Design of CI 3000
9
Version 2.09 09. April 2014
Inputs and outputs
S 2 x inputs 230 V AC (for external alarm and meter reading)
S 3 x outputs 230 V AC floating
2 x alarm contacts, e.g. for telephone dialer
1 x audible signalling unit
S Can be extended with a max. of 4 SIOX extension modules
each SIOX provides
- an additional 12 digital inputs (for meter, alarm etc.) and
- an additional 8 digital inputs (for time switch, load shedding)
S 1 switch (floating 230 V AC) with external wiring option
2.2 New features compared to previous versions
Version 5.12:
‐ Various corrections
‐ Support for further M bus meters
Version 5.0:
‐ Extended alarm and message priorities 3..99
‐ Sending of alarms and messages (incl. to multiple SMS destinations)
‐ Sending of alarms and messages via FAX using an ISDN modem
‐ AUX relay can be used as an alarm relay
‐ Daily test alarm for inspecting the alarm route
‐ Fast CAN bus connection between CI 3000 and Combi Gateway
Danger of a loss of the configuration!
Due to more fundamental changes to the store computer, during an update from version < 5.0 to
version 5.0 and higher it is necessary to re-enter all settings for the error message transmission.
See menu 6-1-4 and all sub-menus.
Version 4.26:
‐ Terminal mode for BMS possible (only CI 3000)
Version 4.24:
‐ Calling up temperature archives (HACCP) on the store computer (see menu 6-3)
‐ M-bus interface for consumption data capture (meter injection) realised
‐ Integration of LDS1 gateways
‐ New special inputs
‐ Text messages from radio sensors now include their sensor ID
‐ Alteration of the factory settings for the system alarms' alarm priorities (see menu 7-4)
‐ Password protection by restricted setpoint changes to interlock the entry
Version 4.19:
‐ SMS text message transmission via a GSM modem