ECKELMANN CI 3000 - Conventions; Explanation of General Instructions; Explanation of Safety Instructions and Hazard Warnings; Warning Signs and Symbols Employed

i
Version 2.09 09. April 2014
Conventions 1.....................................................................
Explanation of 'General Instructions' 1.................................................
Explanation of 'Safety Instructions and Hazard Warnings' 1..............................
Warning Signs and Symbols Employed 2..............................................
1 Safety instructions 3.....................................................
1.1 Disclaimer in the event of non-compliance 4.................................
1.2 Personnel requirements, requirements on staff 4.............................
1.3 Intended use 5...........................................................
1.4 BGV A3 - Five safety rules 5...............................................
1.5 Electrostatic sensitive devices (ESDs) 6.....................................
1.5.1 ESD - Rules for handling and working 6.....................................
1.6 Abbreviations used 6......................................................
2 System Design of CI 3000 7..............................................
2.1 Circuit points 8...........................................................
2.2 New features compared to previous versions 9...............................
3 Application of CI 3000 13..................................................
4 Function of CI 3000 15....................................................
4.1 Alarms and messages 15...................................................
4.1.1 Acknowledgement of alarms and messages 16................................
4.1.2 Remote alarm messaging 17................................................
4.1.2.1 The priority concept 18.....................................................
4.1.2.2 Extended alarm destinations 18.............................................
4.1.3 Suppressing false alarms caused by maintenance work (service mode) 20........
4.2 Relay outputs 21..........................................................
4.2.1 PRIO1 / PRIO2 alarm relay 21..............................................
4.2.2 AUX Multifunctional relay 21................................................
4.3 Digital inputs 22...........................................................
4.3.1 Message and Alarm Inputs 22...............................................
4.3.2 Special Inputs 23..........................................................
4.4 CAN bus station monitoring 24..............................................
4.5 Alarm suppression in manual shutdown of LDS components 24.................
4.6 Configuration of the LDS system via the PC software LDSWin 25................
4.7 Automatic fault report transmission via modem 25.............................
4.8 Display of Temperature Archives (HACCP) on Store Computer 25...............