EDAN H50 - Appendix 4 EMC Information; Electromagnetic Emissions Declaration

H50/H51 Hematology Analyzer User Manual EMC Information
- 68 -
Appendix 4 EMC Information
NOTE:
9 The system complies with the emission and immunity requirements of IEC61326.
9 The system has been designed and tested to CISPR 11 Class A. In a domestic
environment it may cause radio interference, in which case, you may need to take
measures to mitigate the interference.
9 The electromagnetic environment should be evaluated prior to operation of the
system.
9 Do not use the system in close proximity to sources of strong electromagnetic
radiation (e.g. unshielded intentional RF sources), as these may interfere with the
proper operation.
9 Use of this instrument in a dry environment, especially if synthetic materials are
present (synthetic clothing, carpets etc.) may cause damaging electrostatic
discharges that may cause erroneous results.”
Guidance and manufacture’s declaration - electromagnetic emissions-
for all EQUIPMENT and SYSTEMS
Guidance and manufacture’s declaration
– electromagnetic emission
The
system
is intended for use in the electromagnetic environment specified below. The user of
the
system should ensure that it is used in such an environment.
Emission test
Compliance
Electromagnetic environment
– guidance
RF emissions
CISPR 11
Group 1
The
system uses RF energy only for its internal
function. Therefore, its RF emissions are very low and
are not likely to cause any interference
to nearby
electronic equipment
.
RF
emissions
CISPR 11
C
lass A
The
system
is suitable for use in all establishments
other than domestic and those directly connected to the
public low
-
voltage power supply network that supplies
building
s used for domestic purposes.
Harmonic
emissions
IEC 61000
-3-2
Not Applicable
Voltage
fluctuations/ flicker
emissions
IEC 61000
-3-3
Not
Applicable