EDAN H50 - User Login and Access

H50/H51 Hematology Analyzer User Manual Installation Guidance
- 20 -
6. Connect one end of the power supply cable to the power supply adapter and connect the other
end of the power supply cable to the instrument. The connection way is shown below.
7. Plug the main cord to the main power supply. 100-240 VAC; 50/60 Hz; Single phase with
ground
4.4 User Login
Press On/Off button to enter into the Login Screen. Enter operator ID and password, and press Login to
enter into Run Sample Screen.

NOTE:
In order to assure data safety contained in the analyzer, the user can change the
password (123456) provided by the manufacture after first login in accordance with the
procedures described in Section 13.5.6 User Management Setting.




2 levels of access: Administrator and
Operator
. Operator has
limited
accesses compared
with
Administrator.
Please refer to
Appendix 6
for detailed
information.
Regarding the first login, only
Administrator can log in. Thereafter,
Operator access level can be created
and password can be changed
.
Administrator
: Operator ID =
ADMIN,
Password = 123456