Edge-Core EAP101 - Wireless Networks - Network Settings; Figure 45: Wireless Network Settings

Chapter 4 | Wireless Settings
Radio Settings
– 74 –
 DAE Port — The UDP port number to use for DAE messages.
(Default: 3799)
 DAE Client — Specifies the IPv4 address of the RADIUS server.
 DAE Secret — The shared text string used to encrypt DAE messages
between the access point and the RADIUS server.
 Access Control List — Wireless clients can be authenticated for network
access by checking their MAC address against the local database configured
on the access point. (Default: OFF)
 Policy — The MAC list can be configured to either allow or deny network
access to specified clients. (Default: Allow all MACs on list)
 Filtered MACs — List of client MAC addresses. Up to 512 MAC addresses
can be configured.
Wireless Networks —
Network Settings
Figure 45: Wireless Network Settings
The following items are displayed in this section of the Wireless Settings page:
 Network Behavior — One of the following connection methods must be
specified. (Default: Route to Internet)
 Bridge to Internet — Configures an interface as attached to the WAN.
Traffic from this interface is directly bridged into the Internet. (See
Figure 29, “Bridge to Internet", on page 47.)
 Route to Internet — Configures an interface as a member of the LAN.
Traffic from this interface is routed across the access point and out through
an interface which is bridged to the Internet. (See Figure 30, “Route to
I
nternet", on page 47.)
 Network Name — The network to be routed. The default is “Default
local network” as displayed under LAN Settings – Local Network.