Chapter 3
| Network Settings
Hotspot Settings
– 54 –
RADIUS Server
If you click set the mode to External Captive Portal Service or Local Splash page
with External RADIUS, the following section is displayed.
Figure 35: Hotspot Settings (RADIUS Settings)
The following items are displayed on this page:
Enable RADIUS Auth — Enables or disables client authentication via a
RADIUS server.
RADIUS Server 1 — IP address or host name of the primary RADIUS server.
RADIUS Server 2 — IP address or host name of the secondary RADIUS server.
RADIUS Shared Secret — A shared text string used to encrypt messages
between the access point and the RADIUS server. Be sure that the same text
string is specified on the RADIUS server. Do not use blank spaces in the string.
(Range: 1-255 characters).
RADIUS Auth Port — RADIUS server UDP port used for authentication
messages. (Range: 1-65535, Default: 1812)
RADIUS Acct Port — RADIUS server UDP port used for accounting messages.
(Range: 1-65535, Default: 1813)
Enable RadSec — An authentication and authorization protocol for
transporting RADIUS datagrams
over TCP and TLS. RadSec replaces UDP used
in the initial RADIUS design, providing a reliable transport protocol and more
extensive security for the packet payload.
RADIUS Auth Method — Selects the encryption method to use for messages
between the AP and the RADIUS server; CHAP, PAP, or MSCHAPv2. The
encryption method must match that used by the RADIUS server.
To Next Page
Loading...
Need help?
General
