Chapter 5
| System Settings
Services
– 93 –
SNMPv3 User — SNMP protocol version 3 provides secure access by account
authentication and data encryption. An SNMP v3 user can be defined by
clicking the “Add new” button.
Name — The user name used to access the SNMP service.
Access Auth — Select the access permission as “Read” or “Write.”
Auth Type — Select the hash algorithm for authentication.
Auth Pwd — Configure the password for authentication.
Encryption Type — Select the encryption algorithm for data packets.
Encryption Pwd — Configure the password for data encryption.
Multicast DNS The multicast DNS (mDNS) protocol is a zero-configuration service to facilitate
connections within a local networks.
Figure 66: Multicast DNS Settings
The following items are displayed on this page:
mDNS — Enables or disables Multicast DNS on the access point.
(Default: Enabled)
LLDP Link Layer Discovery Protocol (LLDP) is used to discover basic information about
neighboring devices in a network. LLDP is a Layer 2 protocol that uses periodic
broadcasts to advertise information about the sending device.
Figure 67: LLDP Settings
The following items are displayed on this page:
Send LLDP — Enables the sending of LLDP advertisements about the AP to
neighboring devices in the network. (Default: Disabled)
To Next Page
Loading...
